Turn off switch 4 (down on left side) and turn on switch 3 (down on the right side). Then locate the DS1 dipswitches on the control board. Disconnect the actuator connectors plugged into the control board Gate 1 and Gate 2 (X1 and X2).Both LED’s should never be on simultaneously. Adjust the retract limit until the LED goes off and continue to adjust until the gate is at the desired stopping position.
You must adjust the limit switch.Įxample- if both limit LED’s are on when the gate is in the closed position (and actuator is connected to the gate) the problem is with the retract limit switch. Press and hold the “LED Indicator” push button and observe all of the red LED’s If the two limit LED’s located below the actuator plug connector are both on the operator will not operate.Charge or replace the battery depending on results. If switches are correct and the fuses are good and clicking sound is heard, then the battery needs to be load tested to determine its condition. Also check the dipswitches (3 and 4) for correct switch settings based on where the actuator is connected to the control board (Gate 1 or Gate 2).
When pressing the “Open/Close Command” push button, listen for a clicking sound, if no click is heard then verify the 20 amp fuse located in the wiring harness is good.Press the “Reset” push button located above the “Open/Close Command” button, then push the “Open/Close command” push button to operate the gate.Remove control box cover locate the “Open/Close Command” push button and press it to operate the gate.
0 kommentar(er)
